Just as an additional note, this scenario of your system potentially switching to. Go into your BIOS and change your boot order to put the correct drive at the top of the BIOS and you should be fine. Easier for me, less loss for me, during restore times. If so, it sounds like your system might now be trying to boot from the clone target that has the failed clone, rather than the original source. I simply, long ago, chose to make full images of the partitions - one partition, one image. ** I am not against making one full image of a hard-drive from beginning to end, all the partitions. I have only had to restore two Data partitions since 2003 using Norton Ghost Acronis True Image Macrium Reflect & Image for Windows consecutively. Personal experience: I have had to restore OS partitions many times over the years due to various reasons. By drive letter, I mean the normal drive letter assigned by Windows 7 during its normal operations, or, earlier by Windows 7 disk management - because my OS and Data partitions are backed up separately, not rolled up into one image. Regarding keeping track of backup image origins, I name each backup image: YYYYMMDD_S0. Without touching the Data partition, without touching the Data partition's backup, one simply restores the OS partition and keep right on truckin'. Suddenly, the OS implodes or explodes, pretty much no more OS. for 1-2+ weeks (1-2 weeks post the backups - lots of data files have been updated, numerous download EXEs and ZIPs have been added to the stockpile, and so on, onto the Data partition. Type 'chkdsk C: /r /f', with 'C' replaced with the letter of your source drive if different, and press Enter. Why on earth would you backup partitions separately? It is easy to restore a single partition, and keeping them in one image means you are less likely to lose track of which partitions came from where.One example, let's say one has the Data partition backup separate from the OS partition backup. Run CHKDSK to check & repair source disk errors that might cause Macrium Reflect clone failed issue 1.Click 'Start' > 'All Programs' > 'Accessories' then click 'Command Prompt'.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |